DVI to HDMI 1.8m Monitor Cable €9.821 in stock
|More variations available|
Quiet PC DVI to HDMI 1.8m Monitor Cable
This top-quality cable allows a monitor with DVI input to be connected to a PC with HDMI output, or vice-versa.
- High quality HDMI to DVI cable (Type A HDMI to DVI)
- Fully moulded connectors for maximum reliability
- Gold plated contacts for increased conductivity
- Offers much improved reliability over using an HDMI to DVI adapter
This HDMI to DVI cable can be essential if you wish to use an older DVI-only monitor with a PC which doesn’t have a DVI output. It can also be used in reverse if you have a monitor with a HDMI input but a PC with only a DVI output. The cable has fully moulded connectors with gold-plated pins for maximum reliability and signal transfer. It is 1.8 metres long which is the most popular monitor cable length.
Please note that using DVI or HDMI will give a noticeably better picture quality than using an older-style 15-way D-Sub VGA cable, which is the other popular method of connecting legacy monitors to PCs or vice-versa.
As an alternative to this cable, it is possible to use a HDMI to DVI adapter. However, we have experienced problems with using such adapters where they work fine at lower resolutions but when the resolution is increased, (e.g. Windows is started), only a black screen is shown. This is likely to be due to a degradation of the signal quality as it passes through the adapter and because the HDMI and DVI protocols are digital in nature, they either “work or they don’t”. As a result, we recommend using a specifically-designed cable like this one rather than an adapter.
Top Cables and adapters
Quiet PC IEC C13 UK Mains Power Cord, 1.8m (Type G)
Gelid PWM Adaptor Cable for VGA Cooler Fans
Noctua NA-SYC2 3-Pin Fan Y-Cables, 2 pack
Gelid 1-to-4 PWM Fan Splitter
Quiet PC Cloverleaf C5 UK Mains Power Cord, 1.8m
Noctua NA-SEC1 4-Pin PWM Fan Extension Cables, 3 pack
Noctua NA-SRC7 4-Pin PWM Low-Noise Adaptors, 3 pack
Noctua NA-SYC1 4-Pin PWM Fan Y-Cables, 2 pack
Streacom PCI Express 1X Slot Riser Card Adapter Cable
Quiet PC IEC C13 Euro Mains Power Cord, 2m (Type F)
Recently Viewed Products
“Akasa Newton S7”
“I purchased an Akasa Newton S7 case for my Intel NUC board. It arrived on time as described. However while this is a great product there are a few things about it I didn’t like. The first thing that caught my attention was that the heat sink is painted over. This will have a negative impact on the thermal performance, as paint does not have the conductivity that aluminum does (a copper block would have been even better). As I proceeded with the build I found that the cables for the front PCB were extremely stiff which meant that quite a bit of pressure was applied to my board where they attached. Also the case was not quite tall enough to accommodate the unyielding cables, meaning that I had difficulty installing in the bottom plate. The front LED also stopped working within a few days. And if you ripped your board from a NUC chassis, forget getting the internal wifi antennas to work inside the case. The supplied thermal pads for the CPU are also not a good idea as thermal grease is substantially better. I actually used some noctua NT-H1. However, all things considered I am happy with the product. My computer is now absolutely silent and the idle and load temps are actually better than they were with active cooling. Hopefully Akasa can fix some of my gripes in future iterations of this product.”